Adrian revised this gist . Go to revision
1 file changed, 29 insertions
gistfile1.txt(file created)
| @@ -0,0 +1,29 @@ | |||
| 1 | + | # Newer Qualcomm devices need firmware files for HexagonFS. | |
| 2 | + | # Symlink the firmware files if a sensor registry exists. | |
| 3 | + | if [ -d "$BASEDIR"/mnt/persist/sensors/registry/registry ] | |
| 4 | + | then | |
| 5 | + | # Set up the hexagonrpcd firmware directory | |
| 6 | + | HEXAGONFS_BASE="/usr/share/qcom" | |
| 7 | + | mkdir -p "$HEXAGONFS_BASE" | |
| 8 | + | mount -o mode=755,nodev,noexec,nosuid -t tmpfs none "$HEXAGONFS_BASE" | |
| 9 | + | ||
| 10 | + | mkdir "$HEXAGONFS_BASE"/sensors | |
| 11 | + | ||
| 12 | + | ln -s "$BASEDIR"/mnt/vendor/etc/acdbdata "$HEXAGONFS_BASE"/acdb | |
| 13 | + | ||
| 14 | + | # Some devices have a dsp partition, others have /vendor/dsp. | |
| 15 | + | # The ones with dsp partition have a mount point for it at /vendor/dsp, but | |
| 16 | + | # we don't mount it there, so we need to fall back to /vendor/dsp. | |
| 17 | + | if [ -d "$BASEDIR"/mnt/dsp ] | |
| 18 | + | then | |
| 19 | + | ln -s "$BASEDIR"/mnt/dsp "$HEXAGONFS_BASE"/dsp | |
| 20 | + | else | |
| 21 | + | ln -s "$BASEDIR"/mnt/vendor/dsp "$HEXAGONFS_BASE"/dsp | |
| 22 | + | fi | |
| 23 | + | ||
| 24 | + | ln -s "$BASEDIR"/mnt/vendor/etc/sensors/config "$HEXAGONFS_BASE"/sensors/config | |
| 25 | + | ||
| 26 | + | ln -s "$BASEDIR"/mnt/persist/sensors/registry/registry "$HEXAGONFS_BASE"/sensors/registry | |
| 27 | + | ||
| 28 | + | ln -s "$BASEDIR"/mnt/vendor/etc/sensors/sns_reg_config "$HEXAGONFS_BASE"/sensors/sns_reg.conf | |
| 29 | + | fi | |
Newer
Older